Altera JESD204B IP User Manual Page 155
- Page / 158
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Additional Information
8
2015.05.04
UG-01142
Subscribe
Send Feedback
Additional information about the document and Altera.
JESD204B IP Core Document Revision History
Date Version Changes
May 2015 2015.05.04
• Added support for Cyclone V FPGA device family.
• Updated the JESD204B IP Core Configuration values:
• M value from 1-32 to 1-256
• N' value from 4-32 to 1-32
• Updated the JESD204B IP Core FPGA Performance table.
• Updated the JESD204B IP Core FPGA Resource Utilization table.
• Added new parameters to the JESD204B IP Core Parameters table:
• Enable Capability Registers
• Set user-defined IP identifier
• Enable Control and Status Registers
• Enable Prbs Soft Accumulators
• Enable manual F configuration
• Added new topics:
• Timing Constraints For Input Clocks on page 3-13
• JESD204B IP Core Deterministic Latency Implementation
Guidelines on page 6-1
• Revised the note in "Simulating the IP Core Testbench" to state that
VHDL is not supported in Aldec Riviera (for Arria 10 devices only).
• Updated Figure 8-16.
©
2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, ENPIRION, MAX, MEGACORE, NIOS, QUARTUS and STRATIX words and logos are
trademarks of Altera Corporation and registered in the U.S. Patent and Trademark Office and in other countries. All other words and logos identified as
trademarks or service marks are the property of their respective holders as described at www.altera.com/common/legal.html. Altera warrants performance
of its semiconductor products to current specifications in accordance with Altera's standard warranty, but reserves the right to make changes to any
products and services at any time without notice. Altera assumes no responsibility or liability arising out of the application or use of any information,
product, or service described herein except as expressly agreed to in writing by Altera. Altera customers are advised to obtain the latest version of device
specifications before relying on any published information and before placing orders for products or services.
ISO
9001:2008
Registered
www.altera.com
101 Innovation Drive, San Jose, CA 95134
- JESD204B IP Core User Guide 1
- Contents 2
- Item Description 4
- Datapath Modes 8
- IP Core Variation 8
- Run-Time Configuration 9
- Channel Bonding 10
- About the JESD204B IP Core 13
- Getting Started 15
- Upgrading IP Cores 16
- IP Core Status Description 17
- Design Walkthrough 20
- Programming an FPGA Device 25
- Pin Assignments 26
- JESD204B IP Core Parameters 30
- Parameter Value Description 31
- JESD204B IP Core Testbench 35
- Configuration Preset Value 36
- Testbench Simulation Flow 37
- Subscribe 38
- Frame Clock 39
- Transmitter 41
- TX Data Link Layer 42
- Configura‐ 43
- Description 43
- MSB 6 5 4 3 2 1 LSB 43
- User Data Phase 44
- Receiver 45
- RX Data Link Layer 46
- Frame Alignment 47
- Lane Alignment 47
- ILAS Data 48
- Initial Lane Synchronization 48
- RX PHY Layer 49
- Operation 50
- Scrambler/Descrambler 51
- SYNC_N Signal 51
- Link Reinitialization 53
- Link Startup Sequence 54
- Device Clock 57
- Link Clock 58
- Local Multi-Frame Clock 59
- Clock Correlation 60
- Reset Scheme 61
- Reset Sequence 62
- Registers 80
- Access Type Definition 81
- Design Example Components 84
- PLL Reconfiguration 85
- Operation Avalon-MM 86
- Interface Signal 86
- Byte Address 86
- Offset (6bits) 86
- Bit Value 86
- Transceiver Reset Controller 87
- Pattern Generator 87
- Pattern Checker 88
- Transport Layer 89
- F Parameter f 90
- (txframe_clk frequency) f 90
- (rxframe_clk frequency) 90
- TX Path Data Remapping 100
- Altera Corporation 100
- Send Feedback 100
- UG-01142 104
- 2015.05.04 104
- F FRAMECLK_DIV TX Latency 105
- Parameter Description Value 106
- Related Information 113
- RX Path Data Remapping 114
- Serial Port Interface (SPI) 117
- Control Unit 118
- Memory Block (ROM) 119
- Finite State Machine (FSM) 120
- System Parameters 121
- Run-Time Reconfiguration 124
- System Interface Signals 125
- Signal Clock 128
- Direction Description 128
- PHY (Stratix V and Arria V) 133
- Implementation Guidelines 139
- Programmable RBD Offset 140
- Programmable LMFC Offset 143
- K K K K K RK K K K K 146
- D D D DK D D 146
- DK D DK K K 146
- Clocking Scheme 148
- JESD204B Parameters 148
- SPI Programming 149
- Additional Information 155
- Date Version Changes 156
- How to Contact Altera 157
- Contact Method Address 158
Related products and manuals for Measuring instruments Altera JESD204B IP
Measuring instruments Altera Nios II Embedded Evaluation Kit Cyclone III Editio User Manual
(3 pages)
(3 pages)
Measuring instruments Altera Nios II Embedded Evaluation Kit Cyclone III Editio User Manual
(80 pages)
(80 pages)
Measuring instruments Altera Serial Digital Interface (SDI) MegaCore Function User Manual
(140 pages)
(140 pages)
© 2020, manymanuals.com. All rights reserved. | 0.989 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals