103
Figure 6-23 Block diagram of the Music Synthesizer design
Demonstration Setup, File Locations, and Instructions
• Project directory: DE2_115_Synthesizer
• Bit stream used: DE2_115_Synthesizer.sof or DE2-115_Synthesizer.pof
• Connect a PS/2 Keyboard to the DE2-115 board.
• Connect the VGA output of the DE2-115 board to a VGA monitor (both LCD and CRT
type of monitors should work)
• Connect the lineout of the DE2-115 board to a speaker.
• Load the bit stream into FPGA by executing
DE2_115_Synthesizer\demo_batch\DE2_115_Synthesizer.bat file
• Make sure all the switches (SW[9:0]) are set to 0 (Down Position)
• Press KEY1 on the DE2-115 board to start the music demo
• Press KEY0 on the DE2-115 board to reset the circuit
• Note: If the HSMC loopback adapter is mounted, the I2C_SCL will be directly
routed back to I2C_SDA. Because audio chip, TV decoder chip and HSMC share one I2C
bus, therefore audio and video chip won’t function correctly.
Comments to this Manuals