Altera Cyclone V SoC User Manual download pdf (Page 16)

3–6 Chapter 3: Development Board Setup

Restoring the CFI Flash Device to the Factory Defaults

Cyclone V SoC Development Kit November 2013 Altera Corporation

User Guide

f To ensure that you have the most up-to-date factory restore files and product

information, refer to the Cyclone V SoC Development Kit page of the Altera website.

Restoring the CFI Flash Device to the Factory Defaults

To program the factory image to the flash device in the Quartus II Programmer, do the

following steps:

1. On the To ol s menu in the Quartus II software, click Programmer.

2. In the Programmer window, click Auto-Detect.

1 If you do not see USB Blaster or the board's embedded USB Blaster II listed

next to Hardware Setup, refer to the “Installing the USB-Blaster II Driver”

on page 2–3.

3. Click Add File and open <install

dir>\kits\cycloneVSX_5csxfc6df31_soc\factory_recovery\max2_PFL_writer.po

4. Turn on the Program/Configure option for the .pof file.

5. Click Start to download the selected configuration file to the MAX V CPLD.

Configuration is complete when the progress bar reaches 100%

6. Click Auto Detect and a flash device should show up attached to the MAX V in

the main window.

7. Double-click the graphic of the flash device in the device chain pane to display the

Device’s Properties dialog box.

8. Select the flash image .pof file: <install

dir>\kits\cycloneVSX_5csxfc6df31_soc\factory_recovery\output_file.pof.

9. Once the flash image .pof is attached in the Quartus II Programmer, turn on

Page_1 and Option Bits. (Page_0 is reserved for the GSRD factory design.)

10. Click Start.

11. After the flash writing process has completed, power cycle the board and look for

the MAX CONF DONE LED to turn ON if successful.

12. Altera recommends that you return to the Max V System Controller factory design

after completing the flash writing. To do so, program the Max V with <install

dir>\kits\cycloneVSX_5csxfc6df31_soc\factory_recovery\max<version>.pof.

For more information, refer to “Restoring the MAX V CPLD to the Factory

Settings” on page 3–5.

1 The flash writer version blinks the SEL 2, 1, and 0 LEDs and does not support the

Power Monitor, Clock Control, or other logic functions. Use the flash writer only for

flash programming.

f To ensure that you have the most up-to-date factory restore files and information

about this product, refer to the Cyclone V SoC Development Kit page of the Altera

website.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

No comments

Altera Cyclone V SoC User Manual Page 16