Altera USB Blaster User Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
Figure 3-2: Connection to the Device Board
P
I
N
1
T
A
R
G
E
T
B
L
A
S
T
E
R
S
I
D
E
S
I
D
E
10-pin Female Connector
(connects to target printed
circuit board 10-pin male
header)
4. Connect the power cable to the device board.
The Found New Hardware wizard may open and prompt you to install a new hardware driver. Close
the wizard and follow the steps provided in subsequent sections to install the hardware driver.
5. To disconnect the USB Blaster download cable from the device board, follow these steps to ensure that
the cable is not damaged.
a. Remove power from the device board.
b. Unplug the USB-Blaster download cable from the board.
c. Unplug the USB-Blaster download cable from your PC.
3-4
Connecting the USB-Blaster Download Cable to the Board
UG-USB81204
2015.05.04
Altera Corporation
Using the USB-Blaster Download Cable
Send Feedback
Page view 13
1 2 ... 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments